Your Browser is OutdatedReviews by ConcernedCitizen85
Worth the money
Written on Sep 08, 2025
These mags are a great upgrade to 15 round factory ones. The bigger base makes them easier to handle across the board especially when you try to do quick reloads with a mag holster. I used them for a 8 hour pistol class and had no malfunctions at all. They are made in Italy and are a quality mag. I couldn’t recommend these enough for M9 owners.
Worth the money
Written on May 18, 2025
These are cheaper than the factory Ruger mags but I’ve noticed no issues. I think they are much better than the factory ones. I highly recommend them. They are made in the USA. They’re made by C products which makes good standard AR mags
worth the money
Written on Sep 30, 2024
Review for
Radian Weapons AR-15 Extended Bolt Catch
Bought this catch to replace a Geissele maritime bolt catch that was defective and wouldn’t catch the bolt after the last round was shot in the magazine. It came with the roll pin and was easy to install. I like it’s bigger surface area compared to the milspec bolt catch. This fixed my issue and works perfectly. I highly recommend this to anyone.
worth the money
Written on Jun 05, 2024
I did some research on the different thermal monoculars out there before I decided on this one. I like how there isn’t an internal battery. This one and the Odin LTs all run off CR123a batteries or you can spend $80 and get a rechargeable external battery which I recommend. It’s simple to use and has a decent resolution. I had no problem seeing thermal signatures a couple hundred yards away. I was impressed that it picked up on honey bees 30 feet away. The zoom is kinda joke but overall it’s a good thermal in my opinion. According to ATNs website the thermal is made here. I got mine for under $1400. I highly recommend the rechargeable battery since it can run for up to 5 hours and only 2 hours on a CR123a.
Polymer not aluminum
Written on Oct 01, 2023
This is a great upgrade compared to the mount they send with the Protac HLX. It’s expensive for what it is but it’s made well and in the US. I bought this knowing that it’s polymer and not aluminum. Aluminum would be nicer but the polymer seems to be of good quality. It takes a second to get it put together so take your time and don’t over torque the mounting bolts. The instructions say not to tighten the bolts over 12 in. lbs.
1 of 1 found the following review helpful.
typical Magpul
Written on Oct 01, 2023
Replace the milspec cover with the OD one. It was easy to install compared to getting the old one off. It fit and functioned with no issues on a dpms milspec forged upper. I’d recommend this to anyone who wants an upgrade to the stock ejection port cover.
A Great Pole Saw
Written on Jun 15, 2023
Review for
EZ Kut Kamikaze 20' Extending Pole Saw
I bought this saw to cut down some nasty branches on a maple tree in my backyard and seeing that Silky doesn’t make one anymore plus this being made in Spain and not china or some other commie country I decided to go with this one. The biggest branch I cut was about 3” in diameter which I was able to cut with little effort for a manual saw. The expandable pole seemed to be well made and sturdy. My only gripe is that there is no stops on pole sections to stop you from pulling one section out from the other but it’s a small problem. It collapses down to 8’ 6” according to the manufacturer which could be a problem for some people but not for me.
Worth the money
Written on Mar 29, 2023
Picked up two of these for $26 each. They are made in the USA. A quality upgrade to the standard charging handle. They fit with no issues on Milspec uppers. The finish looked good as well. I’d recommend them for someone that wants to upgrade their firearm on a budget.
There are no reviews that match your criteria. Would you like to
reset filters?