David Clark from United States, IN Public Profile

Handguard is OK. I didn’t have it fully seated in the delta ring which was throwing the poi off so much. Still wish it had been designed with locking screws however. It wiggles so I wouldn’t mount an aiming device like a laser on it.

I bought this for the m203 compatible rail notches on the first and last rail slots to fit Knights Armament rail covers for a MK18 mod 0 clone build. Although nicely machined and finished, unfortunately the designers cut corners by not clamping the upper and lower halves with screws. As a result the handguard is not tight and wiggles between the delta ring and end cap. In addition the two halves exert unequal pressure on the barrel which pushed the barrel to the left requiring me to adjust my fixed rear sight all the way left to its mechanical limit to achieve zero. (With a drop in quad rail with clamping screws the sight’s mechanical
zero was pretty much dead on for poa/poi). Because this handguard wiggles it turned a 4 moa gun into a 10 moa gun. Not good. So switching back to my prior drop in handguard that clamps down solidly.

It looks and feels good and stays tight without movement.

Leapers UTG makes (or imports) some good stuff. This sight is made in Taiwan but is made as well as any A2 carry handle rear sight I have used. I like that it attaches solidly to the upper receiver with a torx screw and locktite instead of a bulky knob. It’s holding zero on my suppressed 10.5 inch 5.56 upper with an “F” marked FSB.