Reviews by Jim Presnell
AR Trigger Guard
Written on Nov 12, 2019
Good quality,sturdy for plastic,good fit n finish,lols good,gives plenty of room for a gloved finger without being to big and gaudy of an opening,just always support the tabs on your lower were the roll pins are before tapping the roll pins out or tapping them in,it will break of those thin tabs and ruin your lower
0 of 0 found the following review helpful.
J&E AR Stock
Written on Nov 12, 2019
Product is good quality,functions all,pretty quite for the most part,to change from a CA compliant fixed stock to adjustable just flip the adjustment lever over,it takes a few minutes & roll pins remove extremely easy,that little square cover is a little ruff to remove without damaging it,I used my small rubber mallet & the thin shaft of my roll pin punch,slipped the shaft in the slot and tapped it off quite easily,it is to hard pushing it forward with your fingers unless your part beast lol.
Shipping time was really bad for optic planet,I ordered on 10/28/29,they didn’t ship it till 11/06/19 & I finally received it on 11/10/19 almost two weeks & I never received any updates on shipping or a tracking number until I contacted them on 11/09/19 because I was like dang where is my stuff,then I got an email with the tracking number
Shipping time was really bad for optic planet,I ordered on 10/28/29,they didn’t ship it till 11/06/19 & I finally received it on 11/10/19 almost two weeks & I never received any updates on shipping or a tracking number until I contacted them on 11/09/19 because I was like dang where is my stuff,then I got an email with the tracking number
2 of 2 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?