Your Browser is OutdatedEugene McCurdy from United States, CO Public Profile
Reviews by Eugene McCurdy
Not for 10 round pmags
Written on May 18, 2020
I bought these to go on some 10 round pmags as I'm in Colorado, where I can not legally purchase or manufacture new magazines with a capacity over 15 rounds, and magpul does not make their own 15 round magazines.
Installation is very permanent with not one but two roll pins to hold them in place, making disassembling the magazine after the fact difficult at best. Hopefully you will never need to clean the magazine or replace the follower.
Tested on a brand new 10-round magazine, these only add +4 to the capacity, and will not allow you to seat the magazine on a closed bolt as there is zero extra space past that 14th round. This effectively makes these plates +3 capacity on a 10-round pmag if you plan to load or reload without locking the bolt open.
Installation is very permanent with not one but two roll pins to hold them in place, making disassembling the magazine after the fact difficult at best. Hopefully you will never need to clean the magazine or replace the follower.
Tested on a brand new 10-round magazine, these only add +4 to the capacity, and will not allow you to seat the magazine on a closed bolt as there is zero extra space past that 14th round. This effectively makes these plates +3 capacity on a 10-round pmag if you plan to load or reload without locking the bolt open.
4 of 7 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?