Reviews by Firedog
Ok for what is is
Written on Jul 03, 2020
It uses an infrared red that can be seen by whatever your pointing it at. There is a lot of light flare if you are anywhere near any type of light source. In pitch black darkness it does a pretty good job out to about 150 feet.
3 of 3 found the following review helpful.
Bad manufacturing process
Written on Jul 02, 2020
I purchased the yellow spike model and then inserted into a red lion front sight for a keltec sub 2000 Gen 2 / 40 cal. Took it to the outdoor range to dial it in. With less then 50 rounds down range, the yellow insert fell out, whereabouts unknown. If these inserts come out this easily I would recommend that everyone not that buy them until they get their manufacturing process in order.
10 of 11 found the following review helpful.
dont buy this
Written on Apr 29, 2020
The sight adjusting tool is OK and works well. The Post are made of soft plastic and they will bend when adjusting them up and down. You have have to bend them back to being straight up after you are done.
0 of 0 found the following review helpful.
Good, Bad and the Ugly
Written on Jun 21, 2019
Review for
Bushnell Haste Forward Grip Laser Sight
The Good : I purchased two of these and mounted one on a Keltec Sub2k 9 and the other on a Keltec Sub2k 40 and for awhile they worked good .. The Bad : the one on the 9 stopped working after about 500 rounds were fired .. The Ugly : I couldn't take it off without first removing the Red Lion Front sight, so I ended up cutting it off, better that then have to realign the sight .. I tested it with a new battery and a continuity tester and still didn't work it's .. there is no current going through the switch .. I am giving this item two stars only because the other one still operates ..
1 of 1 found the following review helpful.
Lasermax for Glock
Written on May 02, 2019
This was installed in a Glock 19 Gen 4 - it worked only it was not on target at distanced over 30 feet - No sure what the problem was, so I uninstalled it and reinstalled it in another Glock 23 Gen 4 and the results were the same - Item was returned
2 of 3 found the following review helpful.
Bench rest
Written on May 02, 2019
I am not sure how to rate this item. I received it with one of the leather seems broken open and the contents spilling out inside the shipping box. This could have happened for several reasons. The bag may have been detective to begin with, the bag could have been overloaded with the filler, or it could have been handled hard during shipping. It was returned. My concern would be in reordering another one, if the seems are too easy to break open.
1 of 2 found the following review helpful.
Love these grips
Written on May 02, 2019
Review for
Bushnell Haste Forward Grip Laser Sight
This is low profile laser grip for use on a KelTec Sub2000. When dialed in a 50 yards, you are pretty much right on the money and placing every round inside a 3 inch splatter target at 50 yards all the time is a breeze. I installed these on both the KelTec Gen2 9mm and the Gen2 40cal. After installation, there was still enough room on the rail to attach a Monopod for even more stability.
0 of 0 found the following review helpful.
Fision Night Sights
Written on May 02, 2019
I was not really happy with these sights for a couple of reasons. The dots are the same size. The front sight is lower then the rear sight even though the dots will line up, but it makes it pretty awkward to acquire a fast sight picture. This was when they were placed on the Glock 23 Gen 4 ..
0 of 0 found the following review helpful.
AR front sight post
Written on May 02, 2019
Installed this on a KelTec Sub 2000 inside a Red Lion front sight and it works great. Easy to see and easy to install. If you want something other then the stock flat black front sight post I would highly recommend one of these.
0 of 1 found the following review helpful.
Crimson Trace
Written on May 02, 2019
Put a set of these on both of Glock 19 Gen4's and they work really well. Having the on/off switch that deactivates the laser along with the pressure switch is definitely a good option to have. Easy to install, will not fit on a Glock optional backstrap or over any type of grip options.
0 of 0 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?