Your Browser is OutdatedReviews by First Tymer
Nothing in this kit worked and the Mag realease had not threads on it!
Written on Jun 27, 2020
1. Mag release was smooth and had NO threads on it to screw the button onto.
2. The front take down pin was too short. Once installed it fell slightly inside the opposite loop of the lower. I had to use a punch to gain leverage to push it back through to remove it..
3. The ambi safety selector didnt work at all! If you press it firm agains the side of the lower while installing it will flip on and of BUT the moment you stop pushing it against the lower the selector slides out and then it locks in place and can not be moved..
I was really excited to recieve this, its a shame of this turned out.. It is crazy that so many of these parts dont work. Where is the quality control?
2. The front take down pin was too short. Once installed it fell slightly inside the opposite loop of the lower. I had to use a punch to gain leverage to push it back through to remove it..
3. The ambi safety selector didnt work at all! If you press it firm agains the side of the lower while installing it will flip on and of BUT the moment you stop pushing it against the lower the selector slides out and then it locks in place and can not be moved..
I was really excited to recieve this, its a shame of this turned out.. It is crazy that so many of these parts dont work. Where is the quality control?
1 of 1 found the following review helpful.
No quality control
Written on Jun 26, 2020
I just received my lower parts kits and after assembling most of it, find that the magazine release has NO THREADS on it.. So I’m completely stuck unable to finish my build. Not sure how the button has threads but the release is completely smooth...? The rest of the parts seem ok, I guess... Really worried about the quality Now
1 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?