Your Browser is OutdatedReviews by Gabe
Didn't fit and scratch easily.
Written on Apr 25, 2020
Front pivot pin didn`t fit BCM upper. Rear pivot pin fit fine, but the anodizing was already being scratched off by the detent before I finished building the lower. It also had a lot more friction than milspec takedown pins. My suggestion would be to stick to milspec or maybe try titanium.
0 of 6 found the following review helpful.
Poor fit and questionable durability
Written on Apr 24, 2020
The front pivot pin didn't fit into my bcm upper receiver. The rear takedown pin fit fine, but I noticed the steel detent had already scratched off the anodizing after only using it a couple of times. Sticking with milspec after this experience.
0 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?