Your Browser is OutdatedGS from United States, FL Public Profile
Reviews by GS
Epitome of cheap optics, lol
Written on Mar 20, 2025
Ok, what do you expect for the price. First, the thing needs to be focused, like really focused, very narrow range in focus. Secondly, the image is curved, as in distorted, not flat field at all. Straight pole is curved like a bow as you move across field of view. Haven't fired it yet to see if anything shakes lose. It does seem to be built ok otherwise. Eye relief seems short, but that is likely because the tube is so short, and doesn't go as far back as a regular scope tube. Anyway, I hand to choke up a bit for a good view on an AR-15.
Fits tight, no obvious play at all
Written on Nov 14, 2024
Had to use a tool to pull back the delta ring, but maybe that just age. It fit really tight, no play at all. Final part of upgrade of older 20" AR-15 rifle to newer low profile flattop configuration. Look good too, reminds me a FAL.
Bad parts, needed to hand fit
Written on Nov 05, 2024
Review for
XTS AR-10 Complete Lower Parts Kits
Expensive part kit for bad parts. Hammer was clearly malformed and badly made in hook area, looked like it had been with a drill. Could not get hammer to release, and had to file off the part to get it to work with the disconnector. Would have returned but already installed.
Bad design, don't see how this made it to production
Written on Nov 05, 2024
Spring goes sideways in magazine under follower after about 20 rounds, which is obvious since mag is transparent. Bad follower design, does not extend down to wider part of magazine, so does not stay straight, goes cockeyed almost immediately. Had to load mag several times to get rounds to properly double stack as well.
TRYBE .750 low profile gas block
Written on Jun 16, 2021
Haven't fired yet, but not impressed and expect problems. Fit on barrel and fit to gas tube very loose. This says mil spec but fit no where close to the actual mil-spec gas block/front sight I was replacing. Set screws will fix looseness on barrel, but I expect poor gas tube seal, no way to fix that. Gas tube basically flops around in hole compared to other gas blocks I've tried, and yes. I did try multiple tubes to eliminate the gas tube as a problem. Of course, the roll pin hole is anything but loose, couldn't get it in at all. Currently gas tube held in with 'expedient' solution while I function check. Even if it works ok, I would not recommend.
Aero Precision Black upper, no forward assist
Written on May 20, 2021
This was tight, maybe too tight. Had to bang in the barrel and use barrel nut to seat it. Seemed like alignment slot was interference fit with pin on barrel. Probably should have filed it a little. Used wood block to protect barrel as I 'tapped' it in far enough to use barrel nut. Torqued to lower end of range to 'time' the gas tube, didn't want push my luck trying to go higher, but tight fit so not worried. Upper was also tight on lower, have to press it down a bit to get takedown pin to push in or out, but I'm good with a tight fit there, feels almost like it has an accurizer wedge in it.
1 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?