Your Browser is OutdatedReviews by Gun Builder 86
Nice looking, but may require mods.
Written on Oct 10, 2020
I installed the L2D P80 TiN pins in my serialized p80 (which means the frame comes fully completed from factory, so you know I didn’t mess anything up bc there’s no milling on my part. I have a Zev Fulcrum trigger and the trigger pin was too big to fit in the frame and also too big to fit through the trigger. I had to chuck the pin in a drill and run it with 150 grit sandpaper to remove enough material so the pin would enter. After doing that everything worked flawlessly, and when the TiN finish still looked perfect on the ends of the pins so when installed you can’t tell it’s been modified. It was just a good bit of work to make the trigger pin functional. All other pins were just fine and did not require any work other than installing them.
1 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?