Huey from United States, CA Public Profile

The 1st one I ordered was damaged during shipping, the connector was sticking through the bubble mailer. After dealing with c/s for 2 weeks to get a replacement, they shipped me another in the same style flimsy bubble mailer. While the package wasn't torn, the connector inside of the packaging was bent / flattened out compared to my stock connector. I tried my best to bend it back, but not really sure if it should be a perfect 90 deg bend or what.

I installed the connector and tested it out, well occasionally would not reset the trigger / the next round would not fully go into battery. When this happens the slide feels stuck and I can to forcefully have to get the slide to lock back to clear the jam. I cleaned the firearm and made sure I installed the part correctly. Took it out to the range again and same thing. At this point I've said screw it and reverted the connector back to stock.

Not sure if it's the shipping from OP or that the apex connector is defective, I'm leaning towards the shipping issue, but at this point I'm over it.

The lightened trigger felt good and crisp. But I'd rather have a reliable shooting glock.

I currently used a OP Tac trigger. This part lightens up the trigger pull vs a stock polished connector. Getting to the wall is very light, sometimes I fired sooner than I wanted to anticipating the wall instead of the break. I swapped back to the stock connector to get that wall feeling back, but the break on the stock connector isn't as crisp. Might take a few trips to the range to get used to it.

Built a 10/22 from parts and used this for my chassis. It gives the 10/22 a mini AK look. With a bull barrel and this chassis, it's definitely not something I enjoy shooting off-hand or want to lug around with a sling, but from a bench it's a tack driver. Everything fit like it should and no complaints on the finish and quality.

If there's 1 upgrade you should do to a Ruger Mark series pistol, this would be it. Crisp break with adjustable pre-travel and over-travel.

This URG has given more problems and joy. Failure to feed issues from day one. RMA'ed but still having issues. The same lower receiver/mags/ammo has had zero issues on a different upper. I would love to give this company the benefit of the doubt, but seeing how I'm still having a problems after RMA I'm done with this URG. 3 range trips and all I've done is troubleshoot. This item #1 on my list of having a feeling of buyers remorse of any firearm, or firearm accessory purchase I've ever made.

When ordering a buffer tube kit online, it's really hard to justify paying more for a different brand assuming quality is better. Well this kit from BCM was reasonably priced and I had no issues installing it. Functions like it should and I'd order another for my next build as long as the price is right.

The hardest part was removing the roll pin from my original stock. I wish there was installation pictures, and I had to find a youtube video to figure out how this worked. I'm sure a trip to the hardware store could replicate this kit but you pay for the simplicity and it fit like it should without any permanent modifications to a B5 Bravo stock.

The hardest part was removing the roll pin from my original stock. I wish there was installation pictures, and I had to find a youtube video to figure out how this worked. I'm sure a trip to the hardware store could replicate this kit but you pay for the simplicity and it fit like it should without any permanent modifications to a B5 Bravo stock.