Idaho Mountain Guy from United States, ID Public Profile

I love a light, flat trigger. I normally go CMC, but thought I would throw this on the order.

Writing this because due to surgery, I am past the return date, so this is all I have left.

Thrilled to installed, love the pull and reset.

Took it shooting and started having some issues. There would be soft strikes and the round would not fire. I had issue after issue. This was a build, so I started trouble shooting my possible mistakes. Swapping out components: BCG, buffer spring, uppers, etc. thinking it could be the gas block or the bolt.

None of those were the problem.

Finally discovered the trigger does not fully reset all the time on the bolt retraction, but gets set at half trigger and gives a soft strike next round.

This happened over and over again after scores of rounds. Completely unreliable. Do not recommend.

Very happy with the barrel. Packaging was decent. Thread and chamber protection well done. Barrel crown was interesting, somewhat sharp, but not good.

Fluting is just awesome. Beautiful!

Barrel was completely in spec as far as I can tell by assembly and zero issues.

Fired 10 rounds to ensure functional integrity of build at 10 rounds and then started sighting in at 100 yards.

Barrel performance was awesome!

First two 3 shot groups were sub-MOA, with two round through the same hole on each group. After that, as it was getting pretty cold and I was adjusting the scope, my shooting deteriorated somewhat. But it was still tight groups!

I was using standard PMC ammo, nothing fancy. I was/am prepared to start fiddling with different/heavier grains for accuracy/narrel harmonics, but at this point with standard 55gr ball ammo, it wasn’t even necessary.

HIGHLY RECOMMEND!