Your Browser is OutdatedReviews by Jaison
smaller than I expected but still good
Written on May 06, 2026
I’m not sure why, but I had expected this to be about twice the size. It’s on me because they have the measurements in the description. It’s a neat little thumb stop. I put it on the 45. Feels better against my hand and I can pull back into it just fine. I dig it.
it’s loud, but it works
Written on Apr 02, 2026
Review for
Sniper Muzzle Brakes/Recoil Compensators
Those around you will feel the boom in their chest. They won’t want to sit too close for very long while you’re going through ammo but otherwise it does the job. I have a low mass BCG and together muzzle rise isn’t much. In a scope you don’t leave the target too much but it’s straight, not pushing right or diagonal.
no complaints
Written on Apr 02, 2026
It’s not wearing in any unusual way, seems uniformed. Screws are staked well. Not a lot of soot everywhere so I believe it’s gassing out where it should. I don’t have a gauge set to check bores for efficiency but I don’t see any red flags. The finish looks good. It’s definitely lighter than a regular BCG. I’m happy so far.
looks great and isn’t terribly heavy
Written on Apr 02, 2026
Review for
Shaw AR-15 5.56 NATO Threaded Barrel
I like the finish showing through the hand guard. I nickel plated all of my switches and buttons and this matched those accents well. The firearm is lighter than a 226 wylde I have and they’re basically the same other than BCG & this barrel so I’m guessing the flutes have some part in that. As I understand it, 416R is best for cold climates and I’m in WI so hopefully that is accurate because I’m shooting in 7 degree weather keeping myself warm but that gun is in the cold. All in all, shoots straight for me, looks great, I’m happy.
it worked, but..
Written on Apr 02, 2026
The good is that it did let me tune it, and the threaded pin was easy. The bad is there’s no screw to lock the adjustment screw down and mine backed off eventually. I started throwing casings forward pretty good. Also with it off the gun I was not able to close the passageway completely. Installed it did choke enough to prevent the BCG from cycling and did let me tune it to the sweet spot, but that adjustment screw did work loose later on.
1 of 1 found the following review helpful.
I dig it. Affordable too.
Written on Apr 02, 2026
Works well. Nothing sloppy. It has scope shadow or eye relief, whatever you call it but once it’s set up for you then you find your view easily. The red and green shows clear and bright. If they’re off it looks black just fine too. Loctite the mount screws and you’re good.
not what is pictured
Written on Mar 18, 2026
Review for
Luth-AR AR-15 Adjustable Gas Block .750 ID
I liked that the add showed the +- on the side and seemed pretty regular otherwise. However it came in without any +- on the side. Instead the set screw is on the side, with adjusting from the front. Also the thickness of it as the side ramps from outside the barrel to outside the gas tube is a straight, flat surface in the photo where mine is curved in between the two. Think like hips on person I suppose. It all seems fine so far, just not what I was ordering. Hopefully it’s the same quality or better and not something cheaper in the same packaging. Bag was sealed, all hardware was there and number GB-750-A printed on the bag.
There are no reviews that match your criteria. Would you like to
reset filters?