Reviews by Jason V.
Great for concealability, less so for ergonomics!
Written on Oct 28, 2018
This boot grip is smaller than the Hogue rubber finger grooved grip that comes with the Ruger LCR in both width and length. That means it's better for concealability, but I find it less comfortable in hand. The grip that comes with the Ruger LCR feels more comfortable and fills the hand more, but is much less convenient for my ankle carry in a Galco Ankle Lite. The hard rubber sides of this grip are also less comfortable than the total soft-ish rubber of the factory grip. Comfort or concealability, you pick!
2 of 2 found the following review helpful.
Make sure you know what you need!
Written on Oct 28, 2018
Review for
Wilson Combat ETM Magazine Base Pad
This is completely user error, but I can't use these for my Ruger 1911 magazines. I was too dumb to read the description correctly because these are for Wilson mags, specifically. Though I can't use them right now, the do seem to be of good quality. Very dense and well cast, without burring or seams. Make sure you know what you are ordering!
0 of 0 found the following review helpful.
Great mat for cleaning and takedown!
Written on Oct 28, 2018
Review for
TekMat Gun Cleaning Mats
I bought this to have a nice worksurface for cleaning and takedown. It's a handy size and the material seems to be good quality. It has a little give and the 1911 exploded diagram is useful and more interesting than just a solid color. It's a good size for pistols, but likely too small for rifles.
0 of 0 found the following review helpful.
Great accessory for takedown!
Written on Oct 28, 2018
Review for
Wheeler Universal Bench Block
I bought this to use when I need to remove pins and whatnot from my pistols. It's better than a block of wood or roll of masking tape! It's made of a hard polymer and is lightweight but dense and sturdy. No doubt that this will work as advertised!
0 of 0 found the following review helpful.
Perfect factory part!
Written on Oct 28, 2018
Review for
SIG SAUER Hammer Pivot Pin, 238, Black
I needed this to make the ambi safety on my Sig P938 into a single-sided safety. Worked perfectly and was a simple drop in. This is a Sig Sauer part, not from a third party manufacturer. I would purchase again if needed!
0 of 0 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?