Your Browser is OutdatedReviews by jim
failed attempt at as a support bag
Written on Jan 03, 2025
Review for
Armageddon Gear X-Wing Rear Bag
Construction of bag is great. Quality materials, etc. In actual use it really cant be effectively used as a squeeze bag for rear support. Its too thin and squeezing it becomes a struggle and tiring for mor than a couple shots.
spyderco paramilitary 2
Written on Oct 27, 2024
Great all Roind knife, perfect size for legal carrying in most areas. Big enough but not to large. Fine tip for when doing smaller tasks and broad blade farther back for easy slicing if you need that. Not a thick blade but not delicate either.
primary arms 1x prism
Written on Jul 11, 2024
An extremely nice and solidly built optic. I now own three of them 2 on ar15s and this latest one on a PSA AK. The optic is mounted on a midwest industries qd rail and it seems to be a really nice combo. Optic is clear, lightweight compared to other solutions and allows you to compensate for any offset between open sights and optic center, which is a huge advantage over other types of optics. I used to be concerned about durability of primary arms prisms but they are solid over the last couple of years. I expect this new ine will be the same.
M5 Aeroprecision Upper
Written on Jun 16, 2024
I have built several ar10 pattern rifles using aero uppers and lowers. I have been really impressed with the ease of assembly and quality of the parts. I also use the aero part kits for a smooth, trouble-free build-up. I would recommend these as the basis for any mid to upper priced build. You can absolutely spend more on higher priced parts, but except for brand name, you're not buying additional functionality or reliability.
Works with Beretta 1301 with an easy mod
Written on Dec 11, 2023
Purchased this barrel clamp to get rid of the crummy clamp provided by factory and really wanted to mount a light up front. I ended up going to ACE hardware and picking up 2 new screws (10-32 3/4 inch long black oxide socket heads) Worked great but to protect finish on barrel I applied a single layer of electrical tape on the inside of clamping surfaces otherwise the anodize coating will abrade off the barrel finish. Hope this helps folks looking for a replacement for the factory part. all in all the part is nice, well finished and is secure on the barrel and magazine tube.
11 of 11 found the following review helpful.
nice buffer tube, weight and spring.
Written on Nov 14, 2023
I was a lottle concerned but parts fit perfect and seem to operate just fine. Only possible issue is a minor amount of rust on spring but doesn't impact it functionality
Adding text, adding text, adding text
Adding text, adding text, adding text
looks ok but not
Written on Nov 06, 2023
I purchased 2 of these. Both had undersized roll pin holes making clean-up required. One of the two wouldn't allow the gas tube to seat fully requiring addition work on milling machine. Pure garbage. You could drag a probe along the side of gas tube hole and feel ridged surface from poor machining. I will not buy these again even for budget build.
There are no reviews that match your criteria. Would you like to
reset filters?