Your Browser is OutdatedReviews by Joe Kennerson
Sig Sauer Threaded Barrel in Sig P220 Nitron Full-Size
Written on Apr 19, 2024
The barrel fit and finish are as good as OEM which is the best information a consumer could ask. The barrel allows a Sig P226 full-size OEM .40 cal to now fire .357 Sig....recoil spring and magazines are the same. The chamber is fully supported and the barrel is actually 4.5" long which is an increase of 0.10" over OEM Sig barrel, a definite positive as more barrel length more bullet velocity. Dropped in and cycled cartridges as well as the OEM item. No gun-smithing at all required. My only complaint is once installed, there are NO visible markings on what caliber the barrel is chambered. The barrel is marked .357 Sig but once installed, this marking is no longer visible. So you'll need to have the barrel stamped or laser etched to show the caliber of this hand gun.
Sig Sauer Threaded Barrel in Sig P220 Nitron Full-Size
Written on Apr 06, 2023
Review for
SIG SAUER Barrel, Threaded, 220, 45, Chr
This barrel dropped-in without any fitment issues at all. My P220 Nitron is a police turn-in with a 37A series serial number built in the USA which means a one piece slide. My slide showed wear from previous use which may have aided in this new barrel dropping in a cycling each round without an issue.
There are no reviews that match your criteria. Would you like to
reset filters?