John Galt from United States, TX Public Profile

Purchased two of these, one each for my 5.56 & 300Blk. They sit on offsets and co-witness on the front sight (may require the riser). Easy to sight in, easy to use. I purchased one 6 MOA & one 3 MOA. I prefer the 3 MOA as this works well at 100 yards and doesn't totally cover the target.

I do have one cautionary note: after 2 or 3 30-round magazines my shots were scattered, barely on paper at 100 yards -thought I was having one of "those" days. Turned out, very easy fix. There are two allen screws located just behind the control buttons (used for different mounting options). They had worked loose. The provided wrench fit them nicely. Tighten them regardless if you switch mounting options or not. ...back to nice tight grouping. This happened on both. Definitely NOT a deal breaker! Great sight!

...I'll probably buy a third one for my 7.62.

Added this to my AR15. Due to the close eye-relief on my ACOG (~2"), I needed a charging handle I could easily access up under the scope. This surpassed even my highest expectations! Now I'm ordering another one for my .300 Blkout. Shooting suppressed or not, I just can't go back to the standard handle.

...now, if AXTS only made one compatible with my DPMS AR10.

This was a great improvement for my AR15 & .300 Blkout. It facilitates rapid target acquisition and is a perfect cowitness for my reddot.

The sight adjustment tool leaves a lot to be desired. It could have just been my particular tool (or operator error) but it took a LOT of effort to adjust for elevation. The tool didn't seem to fit well and when it finally did snap into place, the "teeth" would lock up against the spring-loaded pin at the next click, not allowing for a smooth adjustment. It required some coaxing at each click.

...but this just proves my admiration of the sight, I'd still recommend it (just have patience when sighting in).

On both my AR-15 and my.300 Blackout. Clean, crisp, no drag, fast recovery, & easy install! I measured only 2.5lbs of pull ...compare to over 7lbs on factory trigger ...and 4.5lbs on other after market triggers you've heard of. This trigger & a good scope are the two best modifications I've done. Just buy it! I loved it so much I ordered one for my AR-10/.308.