Your Browser is OutdatedReviews by Johnny Rifle
correct length for gas key
Written on Aug 11, 2026
Review for
ZRODelta Mil-Spec Gas Key Screw
Righty tighty lefty loosey, just like mil spec calls for.
These are correct length for gas key.
These are correct length for gas key.
Easy Install, worth the money
Written on Jan 25, 2026
Although you have to disassemble the entire fire control group, this isn't very difficult to install. Utilizes different colors of springs for desired pull weights. Pay particular attention to trigger springs orientations prior to disassembly to ease reassembly, taking a before picture isn't a bad idea. This mod saves a lot of money over purchasing an entire new trigger and while the modified factory trigger may not be as nice as a new high end trigger, it's much more cost effective and will satisfy most shooters.
doesn't run well in remington 870
Written on May 20, 2025
In general, i like these shells. They work fine in my CZ auto loader but not so good in my remington 870 pump. Once the barrel heats up on the 870 the shells tend to hang and the action gets stuck closed. I don't know if this issue is particular to 870's but i have to believe its these particular shells, as my old 870 usually runs anything I've used in it. Nonetheless, I'll continue to use the winchester super targets in other guns, but stick to remington gun club shells in the 870 for light load target and clays.
1 of 1 found the following review helpful.
great workstation
Written on May 08, 2025
Review for
Real Avid Master Gun Workstation
I researched and read reviews on several models before purchasing the real avid workstation and i wasn't disappointed! Ive used to mount and level 2 scopes so far and its worked great.
1 of 1 found the following review helpful.
you need this!
Written on Apr 06, 2025
If you have ever struggled releasing the bolt on your 10/22, or had frustered kids you're teaching, this is a.must have upgrade. Yes, i do know you can modify the existing bolt lock and save the money, but this is a simple drop in fix that takes less than 5 minutes. Save the old bolt release to modify for the next rifle. Dont forget to.retorque the take down screw when you put the action back into the stock.
There are no reviews that match your criteria. Would you like to
reset filters?