Reviews by Jon
precision fitting hand guards
Written on Jul 20, 2017
Review for
AIM Sports Inc AR-15/M4 Handguard/Quad Rail
Two piece drop in, it is not drop in, it will fit but very tight fit. Once you get it wedged in and the screw in it, all four of them. It is VERY solid once it is on. Best with a round front cup on the AR-15. This will fit around the out side of the front hand guard cap or cup, and wedge into the delta ring on the back. Shove the back in first, it will take some pressure, and the barrel nut better be indexed properly or it will never line up and look right.
2 of 2 found the following review helpful.
I love this greta stock!
Written on Jul 20, 2017
Review for
Trinity Force L-E Stock Kit
Perfect fit also has a nice thick rubber pad, less rattle than the original, match it up with there grip for very solid feel. And very low cost! Only problem was I had to install it myself. Auto install would make it better.
0 of 0 found the following review helpful.
Outstanding low cost ar-15 grip
Written on Jun 30, 2017
Review for
Trinity Force AR DMR Grip
Goes on hard and tight, might have to smack it on (be careful of the safety spring) Safety seems a little harder to move after installation of grip. The spring well is slightly shallower than a standard pistol grip, can deepen it with a drill bit so safety is not so hard to rotate around, or just shorten the spring a few coils. I really like the feel of it!
1 of 1 found the following review helpful.
Best clamp on gas block
Written on Jun 06, 2017
I love the clamp on gas blocks, this one is receiver rail height. PERFECT! Perfect gas seal to the barrel, cant get that with a set screw sight block. And it has provisions to put the sling mount on it...
4 of 4 found the following review helpful.
Perfect and low cost
Written on Jun 04, 2017
Review for
Vism Extended Ring Mount
Ordered this for a friends AR build, mounted up just like it should, very solid. Got another one because of the quality of the mount. Just make sure you extend the T nuts out far enough that they go into the MLOK hand guard far enough to properly lock in and tighten down.
1 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?