Your Browser is OutdatedReviews by Kurt
Awesome upgrade over stock stock
Written on May 15, 2022
Review for
Spuhr Stock Assembly for G3,MP5,HK33/53
fits c308!
Awesome upgrade over stock stock. drastic improvement, almost an essential upgrade for the G3 pattern. directions given are vary poor, that is the only reason I am giving four stars out of five. not really able to use iron sights with this new height for cheek weld but I am using an LPVO and this works perfectly.
Awesome upgrade over stock stock. drastic improvement, almost an essential upgrade for the G3 pattern. directions given are vary poor, that is the only reason I am giving four stars out of five. not really able to use iron sights with this new height for cheek weld but I am using an LPVO and this works perfectly.
2 of 2 found the following review helpful.
works great, fitment needed some muscle
Written on May 15, 2022
Review for
Magpul Industries SL Grip Modules
works great, fitment needed some muscle.
have to push very very hard forward in order for the two take down pins to insert correctly, and had to hammer them with a soft hammer to fully seat the take down pins. grip angle is great, is far better than the stock c308 grip module
have to push very very hard forward in order for the two take down pins to insert correctly, and had to hammer them with a soft hammer to fully seat the take down pins. grip angle is great, is far better than the stock c308 grip module
will not work with century C308 trigger pack
Written on May 15, 2022
The safety does not work with century C308 trigger pack, THE HAMMER WILL DROP WITH TRIGGER PULLED AND THE SELECTOR IN THE SAFE POSITION.
I had to swap the trigger pack to the SEF and it works fine. The safety does not work with century C308 trigger pack, THE HAMMER WILL DROP WITH TRIGGER PULLED AND THE SELECTOR IN THE SAFE POSITION.
I had to swap the trigger pack to the SEF and it works fine.
I had to swap the trigger pack to the SEF and it works fine. The safety does not work with century C308 trigger pack, THE HAMMER WILL DROP WITH TRIGGER PULLED AND THE SELECTOR IN THE SAFE POSITION.
I had to swap the trigger pack to the SEF and it works fine.
1 of 3 found the following review helpful.
looks great, sub par bolts
Written on Jun 09, 2021
Review for
AIM Sports Inc AK M-LOK Handguard
I really want to love this hand guard. i love the way its looks/feels once installed. did not come with instruction, took a few attempts to get everything on right (youtube helped) first time installed the barrel clamp on upside down and the entire thing looked canted downward once finished and had to start all over again. the bolts take a small Hex key and will round very easily then your screwed. also noticed after firing a few hundred rounds, there is a gap starting to open up between the hand guard and the receiver. maybe I didn't tighten wedge enough, and now the bolts are rounded and I can't take it off, so I am just going to let it run unless the gap gets so bad i will have to drill out the bolts.
1 of 1 found the following review helpful.
Does not fit PSA AR10 receiver
Written on Jun 09, 2021
Does not fit PSA AR10 receiver, too big for hole, will not insert into slot for safety. Is noticeably thicker in diameter vs standard size. also not true ambidex, one Lever is bigger/thicker than other, should be equal.
There are no reviews that match your criteria. Would you like to
reset filters?