Your Browser is OutdatedReviews by kwik
when needed
Written on Jun 12, 2026
Review for
Obsidian Arms AR-15 Firing Pin Retaining Pin
I started replacing the retaining pin when it shows any wear or when the pins springiness is in question.
Light weight bolt
Written on Apr 21, 2026
Only used once. After 30 rounds and some gas tuning, it works smoothly with a slightly different sound. Will see how well it holds up.
Lighter than the one that came with it.
Written on Oct 29, 2025
Review for
Faxon Firearms 300 Gunner Rifle Barrel
No, I haven't shot it yet; still building with this barrel. Got an amazing deal on an upper, I thought. Not impressed with how much it weighed thou. Wanted a light and maneuverable build, so ordered this barrel. Stout enough to shoot many mags through, and not spreading the MOA all over. From past experience, this should fit the bill. Goes to show it wasn't the deal I thought I was getting.
well built
Written on May 07, 2025
I started with this on the rifle, so I would have to remove it to see what the difference would be. I bought a brass washer from Ace Hardware that had the same OD as the Compensator. I opened the ID with a Dremmel to fit over the barrel threads and used a file and sanding block to set the width to get the top exhaust hole in the right position.I am very happy with the product.
0 of 1 found the following review helpful.
four and more
Written on May 06, 2025
This is my fourth Pic Rail mount. I don't reload, but I don't like slinging my brass around other people either. Just buying the mount allows
you to move the Caldwell brass catcher from AR to AR. If you ever shoot at a range next to people, you should have a setup like this.
you to move the Caldwell brass catcher from AR to AR. If you ever shoot at a range next to people, you should have a setup like this.
Among the best.
Written on Feb 08, 2025
I have many Magpul magazines for several rifles. These feed cartrages well in my 6.5 Creed Moor. Never had a problem with Magpul.
FU-Bag says it all.
Written on Feb 08, 2025
Review for
AT3 Tactical FU-BAG AR-15 Lost Parts Kit
When installing the buffer tube, my finger slipped off the detent plunger, it shot up to the sealing. After a few ricochets, tings, and pings from shelving and boxes, it was lost. After an hour of searching I ordered the FU-Bag. Now I have extra parts if I have any more FUs.
Good mat for the work bench.
Written on Jan 31, 2025
Review for
TekMat 36in Printed Gun Cleaning Mats
I like this mat because the graphics are clear and it seems to be made well.
Good mat for the work bench.
Written on Jan 31, 2025
Review for
TekMat 36in Printed Gun Cleaning Mats
I like this mat because the graphics are clear and it seems to be made well.
good for ocational use
Written on Jan 26, 2025
It works well for what I got it for. It nicely aligns the upper and barrel, and it's a good, solid hold for tightening the barrel nut.
There are no reviews that match your criteria. Would you like to
reset filters?