Your Browser is OutdatedReviews by M
Not cheap enough for the headaches
Written on Mar 27, 2022
If you want to go through ad ream out all the primer pockets yourself to be sure and what to check every case for size and spec, even after running through a sizer die, then these are for you.
These are not cheap enough for the bs. About 2/3 are good, ready to be used brass. You're going to get real mad finding the other 1/3.
These are not cheap enough for the bs. About 2/3 are good, ready to be used brass. You're going to get real mad finding the other 1/3.
2 of 2 found the following review helpful.
Replacement upper is good
Written on Mar 22, 2022
First upper was out of spec, replacement upper is good. It is however so close to spec at the bottom of the rounds chamber, that a in spec round of .374" at the base will be a tight squeeze that will bind a bit. I bought another die that sizes to .373 at the base to avoid this. I have not yet tested the accuracy out of this upper, only one no-optics, eye down the barrel shot for both testing and the ejection of a somewhat bound case that I didn't want to tear my finger up pulling out with the charging handle.
2 of 2 found the following review helpful.
Camber out of spec
Written on Mar 02, 2022
I received one, had to return it because the camber was well out of spec and no rounds could load with the neck space. Returned it for exchange, but that kind of bad quality control is very worrying.
I will update this review when I receive the replacement.
I will update this review when I receive the replacement.
2 of 3 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?