Your Browser is OutdatedReviews by Mark
Must have to used dead air can
Written on Nov 02, 2019
Review for
DEADAIR DA101 5.56 MUZZLE BRAKE
This muzzle break goes on all my Ar15. I have 2 sandman I used with all my rifle. My can gone on fast and tight. No flying off like the silencerco mass moun. I even changed out my maad Mount for keymod to run my saker
3 of 4 found the following review helpful.
Best set up you can have!
Written on Oct 05, 2019
I run jp scs in all my AR it’s the best setup you can have hands down! It’s a little costly then a buffer and spring but worth every Penny. H2 scs I run on all my sbr and regular H for rifle. Easy to install but I little tricky to remove due to the dent
2 of 2 found the following review helpful.
Best scope mount you can buy!
Written on Sep 13, 2019
Review for
Spuhr 34 mm Rifle Scope Mount
Purchased this spuhr mount for a Petra 300wm used a stainer m5xi. The mount is solid very well made. You can tell someone with shooting experience design this mount. After 40 round of 300wm and it still keep zero and none of my screws had try to loosen. I highly recommend this mount for any 308,300wm,338 rifle
1 of 1 found the following review helpful.
My AR10 is so lite now!
Written on Aug 20, 2019
What a difference in weight compared to a SS barrel!! Save a lb. and 1/2 switching out to a carbon fiber barrel. Very well made barrel and had no problem installing it. And looks awesome! Can’t wait to take it out to the range and test it out!
Best setup you can have
Written on Apr 18, 2018
Jp make some awesome parts. There scs is a must have for all AR15 ! The bcg moved so smooth and quite. The gen 2 unit is also so lite! The felt recoil is also reduced you can actually tell a difference. I like there scs so much I change all my standard buffer and spring to JP scs!
Best buffer hand down!
Written on Mar 26, 2018
Ones you experience a jp scs buffer you will not go back to a regular buffer and spring setup! The jp setup is as good as it get. You will tell less felt recoil and your bcg will run like butter! No more springy noise, no more buffer moving. Setup cost a little more but it well worth it! I like it so must I put them all in my ar and furture Build.
Work pretty good
Written on Mar 07, 2018
Before when I was running a regular raptor I would get a good amount of gas blow back at my face with a saker 762. It made it uncomfortable to shoot anything more then 2 to 3 round b4 I have to moved my face away and get some fresh air. After I switch to the HD I noticed there was less gas when I was shooting and you could see the gas coming up from where the gas tube enter the receivers. It has made shotting my suppressor more pleasure to shoot.
5 of 5 found the following review helpful.
Nice shooting glasses
Written on Mar 03, 2018
Review for
Edge OPMOD ZRG+ Shooting Glasses
Pick thee up on sale s d they been my go to shooting glasses. They fit comfortable and you need know you have them on. I usually don’t wear shotting glasses cause they will hurt around my ears at a while but they are very comfortable to wear.
Nice upgrade to stock pins
Written on Mar 01, 2018
These pins fits snug and has a dent at the end of them so you can push them out with a punch and not slip and scratch your gun up. The notch also is cut deeper so your the slide stop locked in a lot better I replaced all the stock pins on my Glock with these. The only complaint I have it I wish the trigger housing was a black color instead of red.
5 of 5 found the following review helpful.
Must have!
Written on Jan 13, 2018
These mag base are really nice and look great! Make the mag drop very fast and they hold an extra 5 round of 9mm. Very easy to install! The only hard part is taking the stock base plate off. These are great for competitions shorting when you don’t have to reload often. Must have for GLock mags!
There are no reviews that match your criteria. Would you like to
reset filters?