Your Browser is OutdatedReviews by Mark Burton
If Ported, buy the 15lb
Written on Nov 21, 2025
I have a few ported 43x/psa micro dagger and these springs are great in those. I run the 15lb in most. I have one that’s over-ported and I run the 13lb spring. I have the 43x with the ramjet and run the 15lb in that also. I only use factory/store brought ammo.
2 of 2 found the following review helpful.
Nice Trigger
Written on Nov 21, 2025
Definitely will be buying again for the 43x/psa micro dagger. Pull weight is a little less than stock, short take up, hard and defined wall, sharp/crisp break. I have five or six apex triggers and prefer this over them. Just wish they had more colors.
Look Elsewhere
Written on Nov 21, 2025
This is not a good completion kit for the 43x. Would not run at all in my Glock 43x slide. And to force the slide off the frame. I thought it may have been the new trigger/lower parts completion kit but I used a different slide and everything worked as it should. I switched the slide internals from my 43x(strike kit) with a micro daggers internals and the 43x ran flawlessly. The problems followed to the micro dagger but not as many as in the Glock slide. All the parts seem too big for the Glock slide and don’t glide/fall into place. They don’t have to be beat in with a hammer but you have to use a little force getting the parts from this kit into the slide. The fitment was worse on the Glock slide compared to the psa slide. I have six 43x’s in total and have built them all and never encountered a problem like this.
1 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?