Your Browser is OutdatedMr1218 from United States, TX Public Profile
Reviews by Mr1218
Great Magazine at the right Price!
Written on Dec 14, 2024
I have purchased 2 of these so far. Both of which have run flawlessly in my MAC 5. I highly recommend these magazines.
Great kit but....
Written on May 28, 2020
So this kit is great but. The description should tell you to ensure the gas port on your barrel is at least.125” and you should purchase the Nemo arms 300 blackout buffer spring. I also had to take.035” off of the oprod so the gas block would be fully over the gas port on the barrel.
8 of 10 found the following review helpful.
Awesome carrier
Written on Apr 18, 2020
This is precisely what i was looking for to wear during Irreverent Warrior hikes! My level 4 sapi plates fit perfectly and there is plenty of room for pouches and patches. I would highly recommend this plate carrier.
1 of 1 found the following review helpful.
Easy install
Written on Jul 17, 2019
I recently installed this on a pistol build. It has stayed installed for 100 rounds so far. It is way easier to install than a typical roll pin. I will leave another review if I experience the “C” clip falling off. But so far so good. Leaving at 4 stars until 500 rounds without loss of “C” clip.
3 of 5 found the following review helpful.
Great for working on small stuff
Written on Jul 17, 2019
Review for
Carson MagniFly LED Lighted Magnifier
This is pretty close to what I was looking for. I think its a little small for my application and the light is a joke. However it has saved me on a few builds and splinter removals. The arm is too short for a large work area.
Best pistol brace I have used.
Written on Jul 17, 2019
I have now used this brace on two builds and it is awesome! Super light, easy to use and looks cool! They come in three colors. Black, OD and FDE. I haven’t used the OD one yet but I’m sure I will one day.
Awesome lower parts kit
Written on Jul 17, 2019
I have purchased two of these from OpticsPlanet. They are really awesome kits. The second kit had no hammer and after contacting OpticsPlanet I had the hammer in the mail in about 4 days. Truly awesome customer service.
Will fit Jack10 upper
Written on Jul 17, 2019
So this is the best handguard I have found for my Jack10. I have 2 of them and they are awesome. This description says high and then says low once you read a little further. OpticsPlanet needs to update it to show if its a .210 upper tang.
1 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?