Neil from United States, OR Public Profile

The choke tube is good and is what was expected and delivered. However the picture that is shown by the online system for this choke tube is not correct. The picture does NOT show that the choke has a Titanium Nitride finish (which is golden in color). The Titanium Nitride is the standard for the 28 Gauge Diana Grade choke tubes. The web site shows a standard SS finish for this particular choke tube..

The case was purchased for a 28 gauge Browning 725 with 30 inch barrels. The case inside length measures 32 7/8 inches. There is a covered half height block (block 1) at the chamber end of the barrel storage location which is 1 5/8 inches wide. There are two additional blocks in the barrel storage area. Measured from the inside left edge of the case, block 2's left edge is 14 1/2 inches and block 3's left edge is 23 inches away. You can store the barrels on top of block 1 OR against the right edge of block 1. If you store on top of block 1, then the you will the total case width of 23 inches for your barrels. Good for a 32 inch barrel O/U shotgun. However, there will be about 1 inch of clearance. I would suggest the use of a user supplied block at the muzzle end to keep the barrels from sliding back and forth. However, if you have 30 inch barrels, you can store the barrels on the right edge of block 1. The barrels are now locked in place because the forearm will be touching the left edge of block 2. A perfect fit! With 30 inch barrels, this will also leave 1 1/4 inches of space for extended choke tube clearances. Bottom line, I would recommend using the 32 inch case for a Browning 725 30 inch barrel shotgun.

This is my second Browning fitted case. This first case, also purchased from Optics Planet, is being used for a 20 gauge Browning 725 with 30 inch barrels.