OutdoorsMen from United States, KS Public Profile

If i was going on just end result it would be 5 out of 5. Going on install much much lower. Before you buy check what version trigger package you have. The install video from FA shows two makes it sound easy maybe a little filling... not so.

If you have a "world legal" you likely are going to have to DRILL out the screw holding in trigger group. Mine was not that it looked easy but turned out full of loctite. Solder iron trick alone could not get the screw hot enough. Ended up using a solder iron, and heat gun both and even then took one heck of a crank. I am lucky it did not strip it I cannot stress how much of a pain this was.

Also they do mention a spot that looks like injection molding on "gen 1" that would need filed. Mine had that but it was flat already or below so no filling.

At this point you would think easy going not much left? Sadly would be wrong. I can't blame FA on this but the CZ safety is a heck of a pain to put in. I do blame them acting like a punch and grease will make it easy in install video. You will be prying with a screw driver most likely hoping to get the little metal piece to go above safety your putting in.

In the end I based on product itself as i do like it if you subtract install. But if you went on install and their video it would have been 1 to 2 star max.