Your Browser is OutdatedReviews by Pat
Out of spec
Written on Jan 24, 2025
The front sight post hole was not centered. I used a micrometer to measure it. Its off centered by over a quarter of a milimeter. I had to dremel it to get my front sight post centered so my rear sight wasn't hanging off the side of the slide. It also does not want to eject brass properly. I swapped every part with my OEM slide and aftermarket parts. No combination seemed to make it eject properly. It works at the range while shooting, but soon as you drop the mag and try to clear it, the cartridge either jams up the slide or drops straight down through the mag well, and you drop the round. This is not ideal.
0 of 1 found the following review helpful.
Came with broken parts
Written on Apr 24, 2024
The firing pin liner sleeve was broken. I ended up buying a brass one anyway, but sucks that it came with broken parts.
1 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?