Pencil Head from United States, FL Public Profile

Purchased Size 14 Right Hand Holster to fit Beretta/Stoeger Cougars - fits both the 9mm 8000F and 40 cal S+W 8040F models nicely and probably the same fit for the 45 cal ACP 8045 model (check the list). It rides nice and high outside of and above your belt, no complaints. Quality appears to be satisfactory and looks like it will last many years to come.

Easy to use and stout. Best to get two 1/4-inch x 1-inch long lag screws and washers and then attach to wood base (I used a 2x10 board remnant about 18-inches long). Mounting on wood base helped to stabilize tool while carefully torquing the new rear sight into the final position. Suggest that you mark where your old rear sight is located to help position your new rear sight. I used masking tape with black ink marks. Place tape on slide where it will not be scraped off during old sight removal then install new sight to align with your tape marks.

Overall, it is intuitive to use, but I wish I could have found instructions with my rear sight tool. There is a good YouTube issued by NcStar that you can watch on how to use it otherwise. It does come with a nice nylon storage case. Basically this tool should pay for itself with one use.

Ameriglo I-Dot front and rear night sights were easy to self-install with NCStar Rear Sight and TruGlo Front Sight tools. Install just one set of night sights and both tools are paid for compared to paying a gunsmith to install, plus you can adjust rear sight alignment if needed. Like other reviewers, I agree that the 2-dot I-Dot design (dot over dot) is faster than 3 dot acquisition, the orange front sight is huge and easy to see in daylight with my older eyes, and the green dots are easy to see in low to no light with the same older eyes. Product quality seems excellent, better price point, and I am very pleased overall. Thanks OP.