Written on Aug 26, 2025
I bought the combo of the slide and the viper red dot since they had a deal at the time on OP. When I went to install the red dot, the dot wouldn’t sit into the slide without me having sand out some material. The tolerance on this might be just a bit too tight with the slide. Anyway, after installation, I notice that the red dot itself has a terrible refresh rate on the lower power settings. I would have to turn it up super high to get it to not have low refresh rate, but that’s a potential issue in low light condition due to the blooming of the dot. I would recommend going with a Holosun if you’re on a budget, or just get an Aimpoint or Trijicon. I wouldn’t buy this again.
0 of 0 found the following review helpful.
Written on Aug 26, 2025
I bought the combo of the slide and the viper red dot since they had a deal at the time on OP. When I went to install the iron sights the slide, I noticed that it was extremely difficult to install the rear sight, even with the sight push tool. Then when I went to install the red dot, the dot wouldn’t sit into the slide without me having sand out some material. The tolerance on this might be just a bit too tight, this is my first Trybe Glock slide, probably wouldn’t buy it again. Maybe it’s just for this particular optic cut, maybe the RMR version is fine. The design is cool though, looks like it’ll work ok.
0 of 0 found the following review helpful.
Written on Oct 04, 2022
Actually fits the +2 Strike mag extensions perfectly. Worked fine so far in all range trips. No malfunctions so far. Slides locked back one with the springs regardless of whether or not you have the extensions installed. Highly recommend.
0 of 0 found the following review helpful.
Written on Aug 01, 2022
I know a lot of optics nowadays are a hit or miss but this one actually surprised me. I have a few “budget” LPVOs but this one easily takes the win. I’ll probably stick with it going forward instead of the strike eagle. Controls are really intuitive and I love the reset functions on the illuminated reticle. So simple yet makes a world of a difference!
4 of 4 found the following review helpful.
Written on Jan 29, 2022
Turns out to be one of my favorite grips. Not as long as I had imagine but that’s not a bad thing, it’s a good size for not being too short or too long. If you like the BCM Mod 3 vertical grip, you’ll like this one.
3 of 3 found the following review helpful.
Written on Mar 27, 2021
Love this sight. One of the best budget sights out there. Clear glass and responsive buttons up top. Battery is easy to swap out. I thought it would be too small but I actually prefer it being small now, you can get a better field of view of the surrounding that way. Highly recommend it if you’re on a budget!
2 of 2 found the following review helpful.
Written on Mar 15, 2021
I highly recommend this kit if you don’t have the need to accessorize too much with your forward assist or dust cover. The dust cover rod comes with the C-clip already preinstalled so you don’t need to mess with it. Assembles in minutes, no complaint whatsoever.
0 of 0 found the following review helpful.
Written on Feb 18, 2021
I have two sets of these because they work well. Surprisingly intuitive compared to mil-spec safeties. Might be a good option for those that have non-traditional grip angles. Highly recommend it on a PCC build.
0 of 0 found the following review helpful.
Written on Dec 17, 2020
This was surprisingly good for its value. Very affordable and easy to install. Can put it as one of the high-value budget parts. Wish it came with m-lok/picatinny rail adapters but you get what you pay for, I recommend it!
0 of 0 found the following review helpful.
Written on Oct 25, 2020
The glass is clearer than I expected. Super easy to adjust the reticle windage and elevation. Positive lockup in on and off positions with the adjustable detents. I’m quite surprised with the magnifier, will keep it on my build!
4 of 5 found the following review helpful.