Rich from United States, TX Public Profile

I am using this in a JP5 PCC for IDPA and USPSA competition. It installed easily with no issues. I have just a couple hundred rounds on it (one testing session and one local IDPA match). It has performed flawlessly so far. I installed it with the 3.5 lb trigger so it feels similar to the JP OEM trigger (Timney) on pull weight and break, reset may actually be a smidge longer (I did not take any precise measurements so just subjective feel at this point). I like a flat trigger bow vs curved for a competition trigger so this was an improvement in my mind over the OEM trigger. I shoot very rapid splits in competition and have in the past experienced a few infrequent issues of trigger freeze with the OEM trigger. Based on the recommendation of another PCC competitor that shoots insanely fast splits I decided to try this SD-3G. So far I am very pleased with the performance. Again, I am moving from the JP OEM trigger which by most measures is a great trigger so I was not expecting a night and day difference but at this point with my limited testing I am completely satisfied and would do it again.

I have a pair of Danner 453 for some time, dont really recall exactly when I got them. I really liked them a lot for comfort and fit. I have not worn them a lot, all the writing on the inside of the tongues is still fully legible but this weekend I put them on and the rubber area that wraps around the heel cracked and separated from the leather on both boots, completely destroying the boots. For reference imaging pulling on the boots by grabbing the back edge above the heel and the entire leather area separating from the rubber insert at the back of the heel. These are marked made in China by the way.