Scoreg from United States, MD Public Profile

Held zero for 40 yards for one mag on a 300 blk 16” with full charge loads. I didn’t shoot any more. Nice product but it does get lost in the brighter conditions. No less or more than red. Might try blue next. Easily mounts on any rail.

Bought this for a straight walled build for state regulation hunting. Mil-Spec tubes did not work correctly with this stock, until I removed the butt plate. Even at that point was very difficult to install far enough to get the tension bolt in. Not a big deal for me since I have threaded spring plug under butt plate. But I did not anticipate having to remove entire stock to get this installed. Other than that, it’s pretty solid and looks good on my rifle. I do think I’d would have rather had the version with cheek rest.

Not overpriced and a good entry for 350 legend AR. 1” at 97 yards repeatable for me. Cycled a bit rough till got an adjustable gas block. I did notice it caught some copper on the ramps a bit more than it should. Think I’m going to polish them and see how smooth it’ll run.

Received this and a few other parts from optics planet that were made by AT3. Cerakote looks good and matches from part to part. They’re just mil-spec but still looks sharper than my powder coated parts.

Liked my first set so much, bought a second set for another one. These are definitely a good buy for the price of them, cheaper than most, but equal in quality. It also came with a Gen4 screw for the front. Took a little longer to get than it originally said, but I’ve noticed that with the shift to DHL for delivery. But no big deal.

So, I received this tonight. Looked at it, and thought, looks pretty good. Feels solid, coatings were good, and pad felt decent for design. Installed the tube, locked in place, took the stop cap off of the stock to allow stopper to draw fully and slide onto the tube. Still liking my purchase, grabbed it wiggled it, very little play. I thought, pretty nice for the price. Went to extend and shoulder and thats when disbelief set in. It came right off in my hand. So, I looked down the opening of the stock and pulled the release lever. The pin dropped completely, even with the cap on. Looking at the pin, first assumption is that it’s too short. I am going to have to “fashion” something to put in place to limit the travel of the pin. I would return, but with the price of this purchase, its more of a burden to return, than it is to tinker with it to make it effective. Other than that, I actually like the fit and feel of this stock for my 9mm. It could use an 1-1/4’ slot for a sling though, but does have one QD spot in the usual.