TTS from United States, NM Public Profile

I purchased one of these for each of our six G19's. We are very happy with all of them. My wife, my son, and I all have experienced 100% reliability when the gun is properly installed. All of us were able to shot significantly more accurately through sets of properly zeroed MBUS's. Followup shots are also much more rapid too. I can reliably ring my 12"x16" steel targets at 50 yards relatively quickly and easily. With a "bare" G19, I'm much slower and lucky to hit more than 2 out every 3 shots at 50 yards. At 25 yards, I can dump a 33-round zombie stick in a circle with a 5" diameter in less than 30 seconds. There is no way in h*ll that I could do that with a "bare" G19! They are very light and compact. The length of pull is slightly longer than a fully extended ar-15 rifle stock, but there's virtually nothing in front of your shooting hand compared to any ar-15. When the pistol grip of a G19 loaded into an MCK is lined up with the pistol grip of an ar-15, the MCK's barrel shroud only extends about an inch past the upper receiver of the ar-15! This makes in highly maneuverable. These are great setups for home or vehicle defense! The fact that the arm braces fold makes them highly concealable and easily stored too! Don't hesitate, get one!

I needed a 10-slot picatinny rail section to mount a pressure switch the hand guard on my AR-15. Not only was this one of the only 10-slot rail sections that I could find, it only requires 2 consecutive keymod holes on one end. This allows for forward extension of the rail past the end of your hand guard or a longer rail section on your hand guard that allows ventilation under most of it.