Your Browser is OutdatedReviews by ucrt
Required fitting that should have been addressed.
Written on Mar 09, 2018
One of the holes for the 2 index pins was not centered between the screws. Both my index pins were centered between the screws and not offset. I called Ruger and they said some are centered and some are not and they do not use the pins now. I heated the barrel up with a blow dryer and pulled the 1 pin out. So, it will have 1 pin that works.
Then, for the extension over the receiver was about a 1/16" too long and the corner was rounded. This would not fit over the receiver. I filed it a little longer and squared the rounded corner and it fit fine.
Just thought for the price it would have fit a little better.
Then, for the extension over the receiver was about a 1/16" too long and the corner was rounded. This would not fit over the receiver. I filed it a little longer and squared the rounded corner and it fit fine.
Just thought for the price it would have fit a little better.
There are no reviews that match your criteria. Would you like to
reset filters?