Your Browser is OutdatedReviews by William W.
NOT UNLESS YOU HAVE A MILLING MACHINE
Written on Mar 21, 2026
These bound-up in the left handle extractor slot in my reprise Gen 1 Glock 17L. I was going to send them back, but could not readily find any with the reduced power spring. Soooo, after checking dimension with my $400 Mitutoyo (spelling?) micrometer, I found that the offender was the raised flat on the inside by the striated thumb release. Using a 1/2 inch end mill, I removed a few thousands of an inch and it fit fine.
AT THIS PRICE?
Written on Mar 16, 2026
After struggling to get the magazine release out of my Glock special re-run of Gen 1 9mm Long Slides, this overpriced POS is too big to slide in the hole at the left side of the handle. Not only “NOT RECOMMEND” but DO NOT EVEN THINK OF WASTING YOUR MONEY!
There are no reviews that match your criteria. Would you like to
reset filters?