Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Most Helpful Positive Review
Decent tool
This tool works really good,but you need to take your time when using it! Make sure everything is lined up right and go slow. Beats using a hammer! Like others, do wish the little push rods were made of a harder metal.
Most Helpful Negative Review
Chinese junk...
This set is Chinese junk made of monkey metal, sold on Amazon same set, under different names.... For like 7-9 bucks and change! Look it up before you buy, no matter from whom... funny enough, as I have stated all that needs stating, I keep getting error messages saying my review isn't long enough...
Read More...
Read More...
simple tool spots when you need.
Great tool. A tool for what is intended. No fidgeting, no bs. This is great for not breaking you lower by hammering way at life.
Would recommend: Yes
Great product
This tool really works well! As a USMC weapons repairman, I highly recommend this tool. �
Pros:
- Everything
Cons:
- None
Best Used for:
- AR15
Would recommend: Yes
Frustration eleminator
after doing the pin install with a punch and scaring the lower, i ordered the tool for the job and completed the next build in mere minutes saving me from time and aggravation. this little tool is worthy of any bench build that you might consider, no more scratched lowers.
George
George
Pros:
- saves the finish of the lower and a lot of frustration
Cons:
- None that I have discovered
Best Used for:
- trigger guard pin installion
Would recommend: Yes
Worked great for me
Had a hard time driving the roll pin in with a hammer and punch. Thought there had to be a better way so I did some research and found this tool. Not sure what the complaints are all about mine worked great for me. I’ll never used a hammer and punch again for my trigger guard roll pin.
Would recommend: Yes
Potter county guy
Wheeler AR trigger guard installer works great beats hammering a pin in and breaking the receiver worth a try.
Would recommend: Yes
It really helps with installing the trigger guard
But if you lose one of the little pins then getting a replacement is next to impossible. I had to buy a whole new one!
Pros:
- does the job
Cons:
- Bad customer service from Wheeler
Best Used for:
- Trigger guard install
Would recommend: Yes
Junk, don't waste your money
I purchased this to install a trigger guard. The idea behind the tool is great, but it is made in China-enough said. The holes don't line up properly, so if you keep screwing the end of the tool in to try to set the trigger guard roll pin, you will break the tabs on your lower and ruin it. I returned for credit, this was less than useless.
Pros:
- None
Cons:
- None
Would recommend: No
0 of 2 found the following review helpful.
Super easy
This product makes installing the trigger guard roll pin a breeze. Use this if you want to eliminate damage to the trigger guard or any need to bang with a hammer. I love Wheeler products. They make life easy.
Would recommend: Yes
1 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to review this product?