Reviews & Ratings for Cimarron Arms Cimmaron Revolver Shoulder Stock 1860/1851/1861 S/steel — 7 reviews — Page 1

I have the Uberti and the Pietta 1860 Army revolvers with the notches on the housing for the shoulder stock to fit on, and although it is very well made and sturdy, it doesn't come close to a good fit for these makes of pistol, so I can only offer 2 stars.

I have been searching for an actual wooden stock for an 1851/60 conversion and had to settle for this one.

I have two of these. One mounted on an 1851 pietta navy and on on an 1860 pietta army. They are fantastic.

This stock is actually a copy of stocks produced by Colt for the 1873 models, and uses a replacement hammer screw that extends out from the frame about 1/4" on each side. It has screws for both Uberti and Pietta replicas, and I installed it on a Pietta 1961 Navy clone. Note that many of the 1851/1860/1861 models have 4 side screws and recoil shield cutouts for the old wooden stocks; this will mount to pistols with or without those features. The stock also has two length bolts for the tension bolt, one for the smaller .36 caliber grip and one for the larger .44 caliber grip. The bottom hook is wider than the slot in the bottom of the grip used by the older wooden stocks, because it isn't intended to be used with slotted grips; this is a pro and a con, in that it will fit more guns, but has a bit of imprecision because of it. I used a small piece of scrap leather between the hook and the butt of the grip to provide more friction than the metal-on-metal contact provided, and that gives a more secure connection.

The result is not 100% authentic, since (based on my research) this style of stock dates from the cartridge era, but it is a fraction of the cost of a reproduction wood stock (if you can find one) and should function just as well.

so first of all its nice to actually find a stock for these models
second this product requires a replacement of one screw on your revolver but first you must remove tension from the main spring
(all parts are provided)
the installation is not very intuitive and though you can take it off once it is installed it is not hot swapable
it is detachable but only on the one revolver you changed the screw on.
Once installed I found it hard to get a sight picture (to get my cheek low enough) might modify).

This product works with both Uberti and Pietta. It is fantastic. Great service and outstanding delivery.