Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Mountie's Review of CMMG, Inc Accuwedge, AR15
The lower receiver cavity where you place this piece on the PSA lower is quite shallow.
To make this fit I had to cut down the base with a well sharpened knife as THIN as possible to the point I was wondering if it would do anything.
Then I had to cut off the front 1/3 of the base.
With all that trimming it just barely fits but it does take all the wiggle out of the my ar15.
It is a little more difficult to push in my rear takedown pin when putting the receivers back together. Because the fit is so tight I do have to use a punch to push out the rear takedown pin.
Overall I’m happy because the product did what I needed it to but with some work.
To make this fit I had to cut down the base with a well sharpened knife as THIN as possible to the point I was wondering if it would do anything.
Then I had to cut off the front 1/3 of the base.
With all that trimming it just barely fits but it does take all the wiggle out of the my ar15.
It is a little more difficult to push in my rear takedown pin when putting the receivers back together. Because the fit is so tight I do have to use a punch to push out the rear takedown pin.
Overall I’m happy because the product did what I needed it to but with some work.
Would Recommend:
Yes
1 of 1
found the following review helpful.