Egw scope base - Evolution Gun Works Picatinny Scope Mount, S/W Revolver

This base was installed onto a S&W 686 stainless steel revolver and was used to mount a red dot optic. After removing the original rear sights the factory drilled and tapped screw holes were exposed on the top strap of the revolver for mounting the scope base. The base fit perfectly even and level on to the revolver and the screw holes in the base lined up correctly with the factory screw holes. The base had an even looking finish and the spacing between the recoil slots was even. The supplied screws fit correctly and did not require shortening.