Perfect for a micro draco! - Franklin Armory BFSIII AK-C1 Trigger - Binary Firing System for AK Platforms

Pretty easy to install. Franklin Armory has a YouTube video to follow along with. Have super glue ready for hammering in the plugs to the holes. Mine popped out a few times before hitting them hard and square enough to get in. I needed to Dremel a small burr from my trigger guard rivets to get the trigger to sit flush. Ten seconds tops, careful not to do too much and touch the finish on your receiver. I didn’t need to adjust the adjustment screw to pass the function tests on the video. I trimmed the sticker to just show the bullets/function positions and it looks much better. Cyclic rate is fantastic! I have a AK Buff medium orange buffer in it that helps the recoil and might help increase the speed of cycling. Wish it had a normal looking AK safety lever to complete the look, but they probably had a reason not to do it. Check out my YouTube video “Binary Micro Draco SBR Dead Air Wolverine PBS-1” to see it suppressed and unsuppressed. Won’t work in my PAP M92 or Underfolder AK because of fit as stated by the manufacturer. Only works in stamped receivers too.