Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Most Helpful Positive Review
Mini 14 Rail for red dot
Nice easy to mount rail for mounting a red dot. Easy installation in notches cut for factory scope rails. Has mounting holes in rail to mount most red dots with out the cross slot adapter. Sits low on gun.
Tom Griner
Easy to install and is solid on my mini-14. Be careful to loosen screws evenly on each side before mounting it so that it sits squarely in the middle, but that is easy to figure out. Screws are small so insert the hex wrench in completely to tighten to avoid stripping the screws. Again, easy to figure out.
Pros:
- Easy to install; solid mount
Cons:
- None
Would recommend: Yes
4 of 4 found the following review helpful.
Light and Durable
I’ve used other Mini 14 mounts before. They usually raise the line of sight uncomfortably high and take up a lot of space. They also tend not to be as secure. This unit is light, stays low profile, especially with a mini red dot, and has cut outs to allow me to remove the bolt for cleaning. Well made product. Be sure to follow included directions as they pre-torque the bolts on one side to ensure a straight and consistent mount to the receiver. No problems holding a zero. All in all a great product. (As a side note, I also installed a rubber buffer on the receiver. With this mount, and less shock going through the rifle because of the buffer, maintaining zero isn’t an issue. I recommend both)
Pros:
- Light and durable
Cons:
- really none
Would recommend: Yes
3 of 3 found the following review helpful.
Ruger Mini 30 Mini Red Dot Mount
The instructions provided were clearly written. The mount was easy to install and is well made. The Vortex Venom Red dot site fit perfectly. I have shot approximately 150 rounds with this mount installed and no shifting of the point of aim.
Would recommend: Yes
1 of 2 found the following review helpful.
There are no reviews that match your criteria. Would you like to review this product?