Free Shipping & Free Returns*

FREE SHIPPING on Over 250,000 Products

Shop now and get Free Value Shipping on most orders over $49 to the contiguous 48 states, DC, and to all U.S. Military APO/FPO/DPO addresses.

Enjoy our FREE RETURNS

We want to ensure that making a return is as easy and hassle-free as possible! If for any reason you are not satisfied with your purchase, simply return the item within 30 days of receipt, and we'll cover the cost of return shipping. Learn more about our Return Policy.

Shopping Cart
Hoppe's 9 Tornado Brush
As Low As $4.95 Save Up to 46%
View Product
Compare (0)
Most Helpful Positive Review Would highly recommend.
It's great that it doesn't have the sharp of the typical bronze bore brushes do, therefore it is not as uncomfortable when tightening the brush down onto the rod (no wires poking your fingertips). More importantly, the brush cleans the bore well. When using a standard wire brush, Spots that had b...
Read More...
Most Helpful Negative Review It works but...
It worked pretty well to brush off debris from my 12G beretta shotgun but brush part came off from the attachment base when I used it for the 2nd time. Maybe I had bad luck or pushed through the barrel too hard but I wasn't expecting this to happen in such a short period of time. I guess I can fix i...
Read More...
Show
Sort by
Filter by

Lives up to the hype

by Steve, from NY, United States Written on July 26, 2017
I was skeptical that something as simple as the design of a brush could be improved, but the tornado brush does represent an improvement. By putting more surface area in direct contact with the bore wall, its continuous spiral of edge cleans far more effectively than the individual bristle tips of a conventional brush. Squirt some CLR down your shotgun bore, let it sit for 15 minutes, and then run the tornado through a few times. Finish up with a patch or two to verify that the bore is clean, and you're done.

I also understand now how the chances of a tornado brush scratching a shotgun bore are slim to none; all edges on the brush have a big enough radius that it would be impossible for them to scratch the bore. I am not certain I would use one on a rifled bore, but I'm committed to it for all my smoothbores.
Pros:
  • Thorough cleaning
Cons:
  • None
Best Used for:
  • Shotgun bores
Would recommend: Yes
2 of 2 found the following review helpful.
Was it helpful to you? Yes | No

Hoppe's brush

by Rich, from MA, United States Written on April 11, 2017
I used this brush on my .45 revolver and noticed a vast improvement in how well the gun barrel & cylinders were cleaned of debris. Seems to be way more cleaning surface over the standard brass bristled brushes which allows for more brush against the surfaces needing to be cleaned. The way this tornado brush is constructed seems to allow it to have a greater durability and I suspect a longer use life. I recommend this product.
Would recommend: Yes
Was it helpful to you? Yes | No

Hoppe's Tornado Brush

by Rich, from MA, United States Written on April 11, 2017
I used this brush on my .45 revolver and noticed a vast improvement in how well the gun barrel & cylinders were cleaned of debris. Seems to be way more cleaning surface over the standard brass bristled brushes which allows for more brush against the surfaces needing to be cleaned. The way this tornado brush is constructed seems to allow it to have a greater durability and I suspect a longer use life. I recommend this product.
Would recommend: Yes
Was it helpful to you? Yes | No

Hoppe's Tornado Brush

by Rich, from MA, United States Written on April 11, 2017
I used this brush on my .45 revolver and noticed a vast improvement in how well the gun barrel & cylinders were cleaned of debris. Seems to be way more cleaning surface over the standard brass bristled brushes which allows for more brush against the surfaces needing to be cleaned. The way this tornado brush is constructed seems to allow it to have a greater durability and I suspect a longer use life. I recommend this product.
Would recommend: Yes
Was it helpful to you? Yes | No

Removes light leading

by Rich, from PA, United States Written on February 14, 2015
I also have one of these for my 9mm. I shoot lead bullets and occasionally have some lead left in the barrel. These brushes work much better than a standard wire brush to remove the lead. It talkes just a few passes with these brushes. The stainless steel does not scratch the barrel. It also works well for cleaning the chamber because the brush seems to be a bit larger in diameter than a wire brush.
Would recommend: Yes
0 of 1 found the following review helpful.
Was it helpful to you? Yes | No

Hoppe's 9 Tornado Brush .38 Caliber

by Legacy Reviewer, Verified Owner Written on May 22, 2012
AWESOME!!!!
buy it
Would recommend: Yes
1 of 1 found the following review helpful.
Was it helpful to you? Yes | No

hoppes brush

by Legacy Reviewer, from WA, United States Written on January 5, 2012
easy to use and works very well.
Would recommend: Yes
Was it helpful to you? Yes | No

Hoppes Tornado Brush .22 Caliber

by Legacy Reviewer, from FL, United States Written on December 11, 2011
Great for stubborn dirt and is not as harsh on barrels.
Pros: Better for stubborn dirt
Cons: none
Would recommend: Yes
1 of 1 found the following review helpful.
Was it helpful to you? Yes | No

works as advertised

by Legacy Reviewer, Verified Owner from CA, United States Written on February 7, 2011
Works as advertised!
Pros: No bristles poking out
Cons: needs to be run through the barrel a couple more times than regular brush
Would recommend: Yes
2 of 2 found the following review helpful.
Was it helpful to you? Yes | No

Just what I was looking for and a great price too

by Legacy Reviewer, from MI, United States Written on June 11, 2010
Keep the good deals coming
Would recommend: Yes
1 of 1 found the following review helpful.
Was it helpful to you? Yes | No
There are no reviews that match your criteria. Would you like to review this product?
Last updated 2025-11-12 UTC.