by
Rick,
Verified Owner
from OR, United States
Written on November 29, 2025
This is incredibly useful for checking reloads. Gauge feels its of quality. It helped me diagnose a couple cases that maybe didn't get fully sized causing slightly stiffer bolt closing. Also checks brass trim length. What's not to like? Highly recommended.
Pros:
- Quality
- easy to use
- reliable
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Phizzlehimself,
Verified Owner
from GA, United States
Written on March 22, 2025
Measures like it should. Well done, Hornady.
Gauges my resized brass well so I know if I need to trim the case.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
RCH,
Verified Owner
from FL, United States
Written on October 13, 2021
Hornady gauges are fantastic case gauges for testing reloads. This gauge is a must have for reloading ammunition. Hornady case gauges are accurate and well built to resist corrosion. I have them in 9mm, 45 ACP, 357 Mag, 40 S&W.
Would recommend: Yes
1 of 1 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Paul,
Verified Owner
from CO, United States
Written on May 12, 2021
Hornady lock n load ammo plant is well known for quality. However, two parts were damaged upon delivery and unpacking. The Case Feeder Bowl and one of three ammo catch cups are broken beyond use. I have registered my ammo plant and advised Hornady of the broken parts. The AP arrived much sooner than expected. OP notice stated expected ship date of 27 May, it arrived yesterday, 11 May. Very nice surprise OP, well done.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Don,
from MA, United States
Written on April 19, 2020
Always a good idea to have these if you are reloading semi auto cartridges. You can easily set your seating die to give the correct amount of "taper crimp" to make sure all rounds will feed in your firearm. Just drop them in and make sure that they fall in to the "GO" marker, but not below the no go line.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Elbert,
from TX, United States
Written on October 8, 2017
Great gauge. Ensures cartridges are within specs. Easy to use even for beginners. Gives you the confidence in your equipment. I use 9mm, 380, 40, 45, 308, 30-30 gauges to ensure I'm keeping within specs for each type of cartridge. I have had no problems at the range or with hunting using reloaded cartridges.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?