Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Most Helpful Positive Review
Just what you need
This is just the ticket for peeking into my cases after a powder drop. There's plenty of light to see down into the brass from just about any ram position, and it doesn't interfere with primer feed mechanisms. The adhesive strip could be a little stronger, as the power cord can easily dislodge the strip. I secured mine with two small zip ties.
Pros: Powerful illumination, no batteries.
Cons: Self adhesive strip is weak
Light for loader
The LED light for the Hornady loader is extremely easy to attach to the loader. It lights up your work area nicely, and is out of the way of moving parts. The adhesive to hold the light on his a little weak, needs to be stronger. Routing the wires can be a little difficult too.
Pros:
- Increases your ability to see what you were doing
Cons:
- Adhesive online to attach is not strong enough.
Would recommend: Yes
A decent light
I have 2 of these installed on my press, and the light output is great. They don't flex 90 degrees very well at all. One of the 2 requires occasional wiggling of the connector to make the light come back on. Other than that they are a fabulous addition to be able to see every station very well.
Pros: Bright and flexible
Cons: Poor connectors
Pros: Bright and flexible
Cons: Poor connectors
Would recommend: Yes
LED light strip hard to adapt to Lee turret press
I had hoped to use this on my Lee classic turret press but it was hard to get the light where it was need to check powder levels in charged case. It was too close to moving parts and I was afraid it might be damaged. I did install it on my Lee classic cast press where it worked out fine. The insulation on the wires was nicked(it arrived that way).
Pros: Installed OK on Lee classic cast press but not on turret press
Cons: insulation on wires was nicked
Pros: Installed OK on Lee classic cast press but not on turret press
Cons: insulation on wires was nicked
Would recommend: Yes
Should be standard equipment on every press
This light strip provides just the right amount of light at just the right place on my progressive loader. I also added a small inspection mirror to look down into the case that I am about to seat the bullet in. Allows me to verify the correct powder level before seating. Without the LED strip, I would have to use a small flashlight and spot check a few cases at random instead of every one.
The only thing I would change about this item is to add an on/off switch to avoid having to unplug the power supply to turn it off. This is a minor inconvenience on an otherwise perfect system and a switch may add too much to the very reasonable cost.
Pros: Easy installation, excellent lighting
Cons: Have to turn on/off with the plug
The only thing I would change about this item is to add an on/off switch to avoid having to unplug the power supply to turn it off. This is a minor inconvenience on an otherwise perfect system and a switch may add too much to the very reasonable cost.
Pros: Easy installation, excellent lighting
Cons: Have to turn on/off with the plug
Would recommend: Yes
3 of 3 found the following review helpful.
There are no reviews that match your criteria. Would you like to review this product?