Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Seems to work for my off-label application.
Works to hold an RCBS bullet puller in a Forster Co-Ax press. I'll be keeping an eye out for scratches and wear in the cast iron.
Would recommend: Yes
4 stars only because my use is "off label", but it seems to perform well in that task.
I needed a ring that would work in my Forster Co-Ax, but had flats on it to tighten a bullet puller collet. It is working well in that role. If I had access to my shop, I would have milled a couple of flats on a Forster ring so I dont have to worry about the steel ring wearing and scratching the bearing surfaces of the press.
Would recommend: Yes
Sure loc ring
Set and forget. Once locked in place it will not move. Then use circle shims to adjust die to
Desired height. Use the sure loc on all my dies.....................................................................
Desired height. Use the sure loc on all my dies.....................................................................
Would recommend: Yes
There are no reviews that match your criteria. Would you like to review this product?