Your Browser is OutdatedPia to install, won't work in a high quality receiver with precise tolerances - KIDD Innovative Design Bolt Handle Charging Assembly w/Guide Rod & Springs For Ruger 10/22
KIDD Innovative Design Bolt Handle Charging Assembly w/Guide Rod & Springs For Ruger 10/22
$51.99
$50.00
Save Up to 17%
View Product
Compare (0)
1 item has been added
Add at least two items to compare
Ider77's Review of KIDD Innovative Design Bolt Handle Charging Assembly w/Guide Rod & Springs For Ruger 10/22
This is the first Kidd product I haven't given a 5 star rating for two reasons:
1) It's a complete PIA to install because of the loose fit handle on the rod. Might not be an issue if you've got small hands, mine are XL to 2XL (depending upon glove quality/brand),
2)Will not work with receiver built exactly to Ruger's minimum specifications (mine is a forged unit machined to Ruger's minimum to + 0.001") with a Kidd bolt because the outside diameter of wound spring (all 3) is significantly larger than ever 10/22 bolt charging handle I've seen. The factory Ruger and a TandemKross charging handles work excellent with my forged receiver, Kidd bolt, Kidd Trigger setup.
1) It's a complete PIA to install because of the loose fit handle on the rod. Might not be an issue if you've got small hands, mine are XL to 2XL (depending upon glove quality/brand),
2)Will not work with receiver built exactly to Ruger's minimum specifications (mine is a forged unit machined to Ruger's minimum to + 0.001") with a Kidd bolt because the outside diameter of wound spring (all 3) is significantly larger than ever 10/22 bolt charging handle I've seen. The factory Ruger and a TandemKross charging handles work excellent with my forged receiver, Kidd bolt, Kidd Trigger setup.
Pros:
- Good for typical factory Ruger Receivers
Cons:
- Too Large for quality receivers machined to Rufer's minimum specifications
Best Used for:
- Upgrading factory Ruger rifle
Would Recommend:
No