Works once you repair it - Leapers UTG QD AK Side Mounts

Arrived looking fine but just would not fit on two different AK's. WAY TOO TIGHT. Could have beat it on with a mallet but afterwards it might never come off....kinda defeats the "quick detach" part and you'll never be able to clean your gun. Problem seemed to be screw was most likely put on with an impact tool, slightly squeezing the mount, thus not letting it fit to the AK's rail. Even after removing the screw (which is CHEAP steel and deforms when you use a screw driver on it), there was still a slight 'bow' between the top half and bottom half of the part which connects to the AK mounting rail. Used two large flat heads (again, screw removed at this point), inserted in opposite directions of gap in rail so I could apply force against the other to slightly and deliberately unbend the mount. Did not want to go too far as the mount still needs to be secure so I worked slowly and kept checking fitment. After a few minutes of this back and forth was finally able to get this mounted snugly. If you apply too much force it would prevent the mount from being secure though.

BTW, not this mount's fault but this type of rail sits STUPID HIGH on an AK with a standard stock. Most likely will need a cheek riser.