Your Browser is OutdatedWell made, but a bit low for my specific scope - Leupold RM Rimfire No Tap Rings
Review for Leupold RM Rimfire No Tap Rings
Compare (0)
1 item has been added
Add at least two items to compare
Jb's Review of Leupold RM Rimfire No Tap Rings
These rings are very well made. Unfortunately the Leupold description says the ring height is 0.85", but that is not the height the ring elevates the scope off the receiver, that is measured from the bottom of ring base to the top of the lower ring
half where the top half joins. Subtract half the scope diameter to calculate the actual scope elevation from the receiver.
half where the top half joins. Subtract half the scope diameter to calculate the actual scope elevation from the receiver.
Pros:
- High Quality, all surfaces machined well, screws fit perfectly.
Cons:
- Too short for planned use - scope requires much higher ring.
Would Recommend:
Yes