It works, but it could be better - Luth-AR MBA-2 Skullaton Stock Assembly

I'll start out and say that this stock works, and is fine if you're not picky. First off, the materials are good, and seems well constructed, and I like the way it looks. I thought it would be a bit shorter than a standard A2 stock, but it's really just about the same. But, it is a bit sloppy on the buffer tube. It does not sit flat on the receiver in the lug area, as it touches the buffer tube "flange" first when tightened down. You can see the gap between the stock and the receiver. The lug on the stock that mates with the hole in the receiver is slightly smaller, you can rotate it ever so slightly. One thing that is unusual in the installation directions, is that it states it uses a short A1 screw, but the screw that comes with the stock is the longer A2 screw that is normally used with the standard A2 spacer. Like I said, it works, but a cheap NBS A2 stock locks up super solid comparatively. Yeah, I'm just picky.