Quick & easy - Lyman 4500 Lube Sizer

There is a youtube video that I found that really made the alignment of the locking screw for the die a breeze to set up. Lower the handle, after inserting the die and putting the screw on top, just to the point of meeting. This will align the screw so it goes in straight, and doesn't get cross threaded. Easy to change dies. I cut my lub sticks in half so I don't have to wait till I'm all the way at the end to insert a new one. I just back off the screw, remove the cap, and insert half a stick, and keep on cranking out those boolits.
Pros: Quick, easy to change dies and top punch.
Cons: Getting the cap screw, that holds the die in place, started without crossthreading

This review was written in the old system and had content requirements that are different than reviews written today.