Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Well made, handy tool
Very handy. I had to completely tear down my Kel-Tec P32 to replace its hammer spring. Replaced other parts while I was in there. The Lyman X Block was a great help with removing and installing pins. The pins get trapped under the block, so they don't go rolling off the bench. The notches were useful for holding pieces at an angle. It is well made and sturdy. Literally took a beating from hammering pins. Glad I made this purchase!
Pros:
- Well made and sturdy. Plenty of holes and notches. Traps pins. Large size.
Cons:
- A little more expensive than other blocks.
Best Used for:
- Gunsmithing
Would recommend: Yes
Just what I needed
Makes it easy and convienent to knock roll pins out of my firearms. Plenty of holes for different size pins. Two different size groves to hold down the firearm. There is a magnetic base so you do not lose the pin if it pops out too fast. Well worth the money!
Pros:
- Soft enough to not mar but hard enough to support gun
Cons:
- None
Best Used for:
- pistols and revolvers
Would recommend: Yes
Just what I needed
Makes it easy and convienent to knock roll pins out of my firearms. Plenty of holes for different size pins. Two different size groves to hold down the firearm. There is a magnetic base so you do not lose the pin if it pops out too fast. Well worth the money!
Pros:
- Soft enough to not mar but hard enough to support gun
Cons:
- None
Best Used for:
- pistols and revolvers
Would recommend: Yes
There are no reviews that match your criteria. Would you like to review this product?